1

PCIe expansion card riser 1 (slot 1 and slot 2)

N/A

The expansion card riser enables you to connect PCI Express expansion cards.

2

BOSS S2 card (optional)

N/A

This slot supports the BOSS S2 module.

3

Rear Handle

N/A

External RJ45 time synchronization connector

4

PCIe expansion card riser 2 (slot 3 and slot 6)

N/A

The expansion card riser enables you to connect PCI Express expansion cards.

5

Rear drive module

N/A

Enables you to install drives that are supported on your system.

6

USB 2.0 port (1)

This port is USB 2.0-compliant.

7

PCIe expansion card riser 4 (slot 7 and slot 8)

N/A

The expansion card riser enables you to connect PCI Express expansion cards.

8

Power supply unit (PSU 2)

This is power supply unit (PSU 2).

9

VGA port

Enables you to connect a display device to the system.

10

USB 3.0 port (1)

This port is USB 3.0-compliant.

11

iDRAC dedicated port

Enables you to remotely access iDRAC.

12

System identification button

Press the system ID button:

- To locate a particular system within a rack.

- To turn the system ID on or off.

To reset iDRAC, press and hold the button for more than 16 seconds.

 

Note:

- To reset iDRAC using system ID, ensure that the system ID button is enabled in the iDRAC setup.

- If the system stops responding during POST, press and hold the system ID button (for more than 5 seconds) to enter the BIOS progress mode.

13

OCP NIC port (optional)

N/A

This port supports OCP 3.0. The NIC ports are integrated on the OCP card which is connected to the system board.

14

NIC port (1,2)

The NIC ports are embedded on the LOM card that is connected to the system board.

15

Power supply unit (PSU 1)

This is power supply unit (PSU 1).